Sony HT-DDW990 - Manual (Page 32)

32 US
Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5]
t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
The table below shows the display when
measurement starts.
* The corresponding speaker indicator lights up in
the display during measurement.
The measurement process will take a few
minutes to complete.
When measurement ends, “COMPLETE”
appears on the display and the settings are
registered.
After you have finished
Disconnect the optimizer microphone from the
receiver.
Note
Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be
maintained.
Tip
The Auto Calibration function will be canceled
when you do the following during the measurement
process:
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.
Performing Auto Calibration
SYSTEM STANDBY
TUNING –
DISC SKIP
MUTING
TV VOL
MASTER VOL
TV CH
PRESET
TUNING +
GUIDE DISPLAY
RETURN/
EXIT
OPTIONS
TOOLS
REPLAY ADVANCE
TV
VIDEO 1 VIDEO 2 VIDEO 3 DVD
SAT TV TUNER
2CH A.F.D. MOVIE MUSIC
SLEEP FM MODE D. TUNING
SA-CD/CD
AUX DMPORT RECEIVER
RM SET UP
?/1
MEMORY
. >
m M
x X
MENU
H
CLEAR
>10
– /– –
< <
DVD
2 3
4 5 6
7 8 9
ENTER 0/10
1
AV ?/1
AUTO CAL
B
V
v
B
AUTO
CAL
Input
buttons
?/1
switch
MUTING
MASTER
VOL +/–
RECEIVER
Measurement for Display
Environment noise level NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately*
Speaker level MEASURE and
GAIN appears
alternately*
Speaker distance MEASURE and
DISTANCE appears
alternately*