SVAT Electronics CLEARV U6 - Manual (Page 2)

CLEARVU6 QUICK START GUIDE
STEP 2: Monitor Installation
For more information on your SVAT product please visit: www.svat.com
9. Plug the “3.5mm to RCA (female) wire”
into the AV1/IN port on the monitor.
10.Plug the camera’s RCA output plug into the
video input (yellow) end of the “3.5mm to
RCA male wire.”
11.Repeat steps 1 and 2 for connecting a
second camera to the AV2/IN port on the
monitor.
NOTE: Please review the manuals
for the included camera and monitor
which can be found in their respective
packages.
1. Hold the adjustment head as
shown in Diagram A. Remove
the wingnut (part 1) by turning
it counter-clockwise. Make
sure you hold the adjustment
head tightly while moving the
wingnut.
2. Holding the adjustment head
on its side as shown in Diagram
B, lift part 2 (including the
screw)
3. Holding parts 3 and 4 securely
as shown in Diagram C, connect
part 3 and 4 to the top of the
mount stand.
4. While continuing to hold parts
3 and 4 securely, insert part 2
(including screw) into parts 3
and 4 as shown in Diagram D.
5. While holding the adjustment
head as shown, thread the
wingnut onto the screw by
turning the wingnut clockwise.
6. If you need to adjust the
mounting plate or adjustment
head, loosen the wingnut
slightly, adjust, and retighten.
7. If necessary, loosen the
mounting plate knob by it
turning counter-clockwise.
Slide the mounting plate into
the monitor’s mounting rail as
shown.
8. Secure the mounting plate
to the monitor by turning
the mounting plate knob
clockwise.
Diagram A
Diagram B
Diagram C
Diagram D