Chapter six: faq – ST & T WCAM71 User Manual
Page 16
Advertising
© 2003 ST&T Group. All rights reserved.
16
Chapter Six: FAQ
Q: IP Camera WCAM71 cannot show image.
A:
Reset IP camera WCAM71 and re-login.
Try to set image parameters as QVGA (320x240) and low quality. Sometimes the
condition of network is bad, and the image is not complete. The browser only shows
complete image.
Q: Sometimes the Network setting doesn’t work.
A: Some IP address are reserved – “255.255.255.255”, “0.0.0.0”, “127.0.0.0”, “127.0.0.1” and
“X.X.X.255”. You can’t use these IP address.
Advertising