Samsung SCC-B2035P - Manual (Page 26)

26 – DIGITAL COLOR CAMERA
How to use OSD Menu
OTHER SET
eOTHER SETf
EXTERNAL TRG OFF
FACTORY DEFAULTS
OSD COLOR
BW
EXTERNAL TRG
Set the EXTERNAL TRG menu to ON and press
the SETUP switch to display the appropriate
screen.
‹EXTERNAL TRG‹
STILL TIME OFF
DELAY TIME FIX
You can set the STILL TIME to 0~4 seconds.
If DELAY TIME is set to FIX, the DELAY TIME will
be set in sync with the STILL TIME; if set to USER,
the DELAY TIME will be set to your setting.
Note :
If VPS is set to OFF, the EXTERNAL TRG menu will be
deactivated.
FACTORY DEFAULTS
All the settings will be restored to the factory
default.
However, the settings of PROTOCOL, BAUD
RATE, ADDRESS and LANGUAGE will not be
restored to the default.
OSD COLOR [BW, R/G/B]
You can set the OSD(On-screen Display) color to
COLOR or B/W.
❖

–
❖
❖
COMMUNICATION
eCOMMUNICATIONf
RS-485
PROTOCOL
SAMSUNG
BAUD RATE 9600
ADDRESS 0
The COMMUNICATION menu is used to confi gure
the settings regarding RS-485 communications.
Use the rear panel of the camera to connect to
RS-485.
[Camera I/O Connector]
Use the
cdef
switch to specify the protocol,
baud rate and address (0~255) for communications.
PROTOCOL
Select a communication protocol.
BAUD RATE
Select a baud rate.
Note :
The baud rate differs, depending on the specifi ed
protocol.
ADDRESS [0~255]
You must specify a unique address for each
camera in the same RS-485 network.
To control a specifi c camera, you must match the
address of the camera with that of the DVR or the
controller.
❖
❖

–
❖
SYS
You
proto
versi
LAN
The c
Selec