Samsung SPINPOINT HS122JF - Manual

Ultra mobile SATA
Spinpoint N1C
80GB 120GB
HS08XJF HS122JF
FEATURES
• MAX.60GB Formatted Capacity Per Disk • SATA S.M.A.R.T Compliant
• High Speed Digital Signal Processor Based Architecture • SATA 48-bit Address Feature Set
• Low Power HDC • Multi-Burst On-The-Fly Error Correction
• Advanced Power Management Control • SilentSeek™
• Fluid Dynamic Bearing Spindle Motor Technology • Free Fall Sensor (optional)
Capacity 80 / 120 GB Temperature
Interface SATA 1.5Gbps Operating 5 ~ 60 ℃
Rotational Speed 5400 RPM class Non-operating -40 ~ 85 ℃
Buffer DRAM Size 8 MB Humidity (non-condensing)
Byte per Sector 512 Operating 8 ~ 90 ％
Non-operating 8 ~ 90 ％
PERFORMANCE SPECIFICATION Linear Shock (1/2 sine pulse)
Capacity
DRIVE CONFIGURATION ENVIRONMENTAL SPECIFICATIONS
Model
Average Seek time (typical) 14.0 ms Operating, 2ms 600 G
Media Transfer Rate (Max.) 550 Mb/s Non-operating, 1ms 1500 G
Interface Transfer Rate (Max.) 1.5 Gbps Vibration
Drive Ready Time (typical) 4.0 sec Operating 0.67 Grms
Altitude (relative to sea level)
RELIABILITY SPECIFICATION Operating -300 to 3.000 m
Non-recoverable Read Error 1 sector in 10^13 bits Non-operating -400 to 15,000 m
Controlled Ramp Load/Unload 600,000
PHYSICAL DIMENSION
ACOUSTICS Height 8.0 mm
Idle 2.4 Bel Width 78.5 mm
Performance Seek 2.6 Bel Length 54.0 mm
Weight (Max.) 62 g
POWER REQUIREMENTS
Voltage +3.3V ±5%
Spin-up Current (Max.) 540 mA
Seek (typical) 1.30 W
Read/Write (typical) 1.60 W * Note : Design and specifications are subject to change without prior notice.
Idle (typical) 0.40 W 1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
Standby (typical) 0.12 W * Accessible capacity may vary as some OS uses binary numbering system for
Sleep (typical) 0.10 W reported capacity.
* A small portion of the (8MB) buffer memory is reserved for firmware use.
1.8" N1C SATA product specification Rev.08
Match with 1.8" N1C SATA product manual Rev.07