Siemens X-400 - Manual (Page 73)

Installation and Commissioning
Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches
C79000-G8976-C186-03
73
Figure 6-3 Inserting a media module
Removing a Media Module
To remove the device, you require a slotted screwdriver with a 2.8 mm wide blade.
Note
Removing a fast Ethernet media module is the same in the SCALANCE X414-3E
and in the media module extender.
1. Remove the inserted labeling strip from the front of the media module.
2. Release the captive screw on the front of the media module as far as it will go
with a slotted screwdriver with a 2.8 mm wide blade.
3. Press on the fluted middle section of the top of the media module next to the
backplane.
4. At the same time, tilt the media module down at an angle, the two guides ini-
tially remain in the recesses at the lower edge of the basic device.
5. Remove the media module by pulling it upwards.
6. Fit the protective cap on the module terminal strip on the backplane of the ba-
sic device. Fit the appropriate cover (see section 6.2.2) to the slot of the media
module.