Sony SNC-RZ25P - Manual (Page 33)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the System — System setting menu
33
Interval
Select the interval at which you want to adjust the
camera’s time referring to the NTP server’ time,
between 1 and 24 hours. The set interval is a guide, and
does not indicate the exact time.
Note
The setting time may not accord with the exact time
according to the network environment.
Time zone
Set the time difference from Greenwich Mean Time in
the area where the camera is installed.
Select the time zone where the camera is installed from
the drop-down list.
Automatically adjust clock for daylight saving
time changes
When you select it, the clock is automatically adjusted
according to the daylight saving time of the selected
time zone.
Note
If the time zone selected on the Time zone menu is
different from that set on the computer, the time is
adjusted using the time zone difference and set on the
camera.
OK/Cancel
See “Buttons common to every setting menu” on page
29.
Initialize Tab
Reboot
Reboots the camera.
Click Reboot, and the message “The SNC-RZ25N/
RZ25P will be rebooted. Are you sure?” appears. Click
OK to reboot the camera. It takes about two minutes to
start again.
Factory default
Resets the camera to the factory settings.
Click Factory default, and the message “Set up data
will be initialized. Are you sure?” appears. When you
click OK, the network indicator on the camera starts to
blink. After adjustments of the default settings have
finished, the camera reboots automatically. Do not turn
off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning the power on of this unit while pressing the reset
switch on the camera. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera. The file name preset at the factory is “snc-
rz25.cfg.”
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.
Notes
• With Restore setting, some items in the Network
setting menu (page 40) cannot be restored.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– a panorama image recorded in the camera using
SNC panorama creator
– a homepage created using Custom Homepage
Installer
Delete user setting URL
By pressing Delete, you can delete the home page
recorded on the flash memory of the camera with
Custom Homepage Installer (page 77).
Delete panorama image
By pressing Delete, you can delete the panorama image
recorded on the camera with SNC panorama creator
(page 75).
Firmware upgrade
Use this when upgrading the camera software. Click
Browse and specify the file for upgrading, then click
OK. The message “Upgrade firmware? Are you sure?”
is displayed. Click OK and upgrading starts. After
completion, the camera starts again.