Sunbeam 3258 - Manual (Page 5)

3
PM
S
ETTING THE
C
LOCK
1. Press “Hour” button and hold in until the correct hour shows on the clock, then release.
Note the “P.M.” indicator on the display.
2. Press “Minute” button and hold in until the correct minute shows on the clock,
then release.
Note: Manual “On” mode will not function until clock time is set with hour and minute
buttons. “Automatic” mode can be selected before clock time is set by sliding
switch to “Off” first and then to “Auto”.
2. Place filter without coffee in the basket and swing to closed position. Place carafe on
warming plate. Switch control to “On”. During cleaning more steam will occur than
during normal brewing.
3. KEEP THE COFFEEMAKER ON UNTIL CARAFE IS HALF FULL. Switch control to “Off”.
When liquid stops dripping from filter basket into the carafe, remove the basket and
carafe and allow liquid to cool in the carafe for 15 minutes. When cooled, pour liquid
back into the water chamber.
4. Replace basket and return carafe to hot plate.
5. Switch control to “On”. Repeat procedure allowing all the cleaning solution to empty
into the carafe. After dripping has stopped discard contents of carafe.
6. After allowing coffeemaker to cool for 10 minutes, rinse it out by brewing without coffee
a carafe full of cold water.
7. At end of brew cycle, switch control to “Off”. Discard water in the carafe.
Remove filter and wash carafe and filter basket in hot soapy water. Dry parts.
8. When coffeemaker has cooled, wipe base with a dry cloth.
Any servicing requiring disassembly other than the above cleaning
should be performed by an Authorized Service Representative.
Hour
Minutes
Brew Button
On/Off/Auto
Auto Light
On Light
SPECIAL INSTRUCTIONS: Only for Deluxe Coffeemaker model.
How to use the electronic timer and auto off function.