Speed Queen LES37A*F - Manual (Page 14)

Installation
510988 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 3: Connect Electrical Cord
(240 Volt/60 Hertz)
Refer to section on Electrical Requirements.
Figure 4
Step 4: Wipe Out Inside of Dryer
Before using dryer for the first time, use an all-purpose
cleaner, or a detergent and water solution, and a damp
cloth to remove shipping dust from inside dryer drum.
Figure 5
Step 5: Connect the Dryer to Electrical
Power
Refer to section on Electrical Requirements, and
connect the dryer to an electrical power source.
Heat Source Check
Close the loading door and start the dryer in a heat
setting (refer to the Operation section). After the dryer
has operated for three minutes, the exhaust air or
exhaust pipe should be warm.
D703I D679I
NOTE: Dryer is shown with access cover removed for illustration purposes only. NEVER operate dryer with access
cover removed.
D703I
D679I
TWO-WIRE CONNECTION THREE-WIRE CONNECTION
D618I
D618I