Installation instructions, Secure the drain hose, Level the washer-dryer – Splendide AW122 User Manual

Page 17

Advertising
background image

17

2. Attach the hose connected to the ‘H’ valve to the hot

water faucet. Screw on the coupling BY HAND until it is

seated on the gasket. DO NOT OVERTIGHTEN.

3. Attach the hose con-

nected to the ‘C’ valve

to the cold water faucet.

Screw on the coupling

BY HAND until it is

seated on the gasket.

DO NOT OVERTIGHTEN.

4. Turn on the water

faucets and check for

leaks.

Secure the Drain Hose

1. Drape the power cord over the washer top.

2. Secure the drain hose to the laundry tub leg or

standpipe with a strap or cable-tie.

3. Use the U-Clamp (provided) and insert the drain hose

into the standpipe or sink. DO NOT force excess drain

hose into the standpipe. There should be only 6” of

drain hose in the stand pipe.

Level the Washer-Dryer

After positioning the washer in it’s final installation

location, you must level the washer.

The front feet are self

locking and adjustable.

Your machine will be

noisy if the two front feet

are not adjusted so the

machine stands firm and

level.

1. Tilt the machine

back, leaning it

against the wall.

2. Adjust the front feet up or down to ensure the

washer is resting solid and does not rock side-to-

side or front-to back when the machine is upright.

H

C

20" (50 cm) min.
with an air break

25" (62 cm) min.
34" (86 cm) max.

6" max.

Standpipe

U-Clamp

IMPORTANT!

The couplings should be tightened BY HAND,

a tool should only be used if a leak occurs. Do

not use excessive force.

Installation Instructions

IMPORTANT!

When moving washer to it’s final location,

take care not to kink the inlet or drain hoses.

DID YOU KNOW?

The majority of problems with noisy
machines or excessive vibration are due
to the transit SCREWS/SPACERS NOT
BEING REMOVED or the FEET NOT BEING
ADJUSTED correctly to level the machine.

SecureFit Brackets,

Part No. MKO1

Optional

Splendide SecureFit™

Installation Brackets, Part

No. MK01

• Hook around two front feet

and screw into the floor.

• Designed to keep the washer

from shifting front-to-back or

left-to right.

• Recommended for RV or

Marine Installations.

Advertising