Sony UWP Series - Manual (Page 11)

Bodypack Transmitter Handheld Microphone Plug-on Transmitter
Oscillator Crystal-controlled PLL synthesiser
Type of emission F3E
Carrier frequencies 798 MHz to 822 MHz (TV channels 62 to 64) or 838 MHz to 862 MHz (TV channels 67 to 69)
Users may choose from 189 frequencies on each model.
RF power output 30 mW or 5 mW (selectable) 30 mW or 5 mW (selectable) 50 mW
Antenna 1/4 λ wave length wire 1/4 λ wave length wire (internal) Integral type
Pilot tone signal 32 kHz
Frequency response 50 Hz to 18 kHz (typical) 100 Hz to 18 kHz (typical) 50 Hz to 18 kHz (typical)
Reference deviation ±5 kHz (-60 dBV, 1kHz input) ±5 kHz (94 dB SPL, 1kHz input) ±10 kHz (-60 dBV, 1kHz input)
Signal-to-noise ratio 60 dB or more (±5 kHz deviation at 1 kHz modulation, A-weighted) 60 dB or more (±10 kHz deviation at
1 kHz modulation, A-weighted)
Microphone capsule — Dynamic capsule (uni-directional) —
Audio attenuator adjustment range 0 to 21 dB (in 3 dB steps)
Audio input level -60 dBV (at 0 dB attenuator level) — MIC input position: -60 dBV (at 0 dB
attenuator level), LINE input position: +4 dBu
Audio input connector 3.5 mm (5/32 inch) dia., 3-pole mini jack — XLR-3-11C type
Max. input sound pressure level — 151 dB SPL (at 21 dB attenuator level) —
Indicators LCD Operating channel number/frequency, attenuator level, RF-output level (High/Low), audio input status Operating channel number/frequency, attenuator-
transmitter battery status and accumulated operating time level, audio input status, RF-output status,
transmitter battery status and accumulated
operating time
LED Power status Audio-input status
Power requirements DC 3.0 V (with two AA-size alkaline (LR6) batteries)
Battery life Approx. 6 hours with Sony AA-size alkaline (LR6) batteries at 25 °C (77 °F) at 30 mW output Approx. 6 hours with Sony AA-size alkaline
(LR6) batteries at 25 °C (77 °F) at 50 mW output
Dimensions (W x H x D) 63 x 100 x 27 mm (2 1/2 x 4 x 1 1/8 inches) φ52 x 240 mm (φ21/8 x 9 1/2 inches) 44 x 99 x 36 mm (1 3/4 x 4 x 1 7/16 inches)
Mass Approx. 140 g (4.9 oz) including batteries Approx. 300 g (10.6 oz) including batteries Approx. 185 g (6.5 oz) including batteries
Supplied accessories Omni-directional (UWP-C1)/Uni-directional Microphone holder (x1) Soft case (x1)
(UWP-S1/X1)lavalier microphone (x1),windscreen (x1),
microphone-holder clip (x1), belt clip (x1)
Portable Tuner Half 19-Inch Rack-Size Tuner Tuner Module
Oscillator Crystal-controlled PLL synthesizer
Type of reception Space diversity
Receiving frequencies 798 MHz to 822 MHz (TV channels 62 to 64) or 838 MHz to 862 MHz (TV channels 67 to 69)
Users may choose from 189 frequencies on each model.
Antenna 1/4 λ wave length wire
Pilot-tone signal 32 kHz
RF squelch level 15 dBµ 25 dBµ
Frequency response 50 Hz to 18 kHz (typical)
Reference deviation ±5 kHz (at 1kHz modulation)
Signal-to-noise ratio 60 dB or more (±5 kHz deviation at 1 kHz modulation, A-weighted)
Audio output connector 3.5 mm (5/32 inch) dia., 1/4-inch phone jack (unbalanced) –
3-pole mini jack (x1), unbalanced or XLR-3-32 type (balanced)
Audio output level -58 dBm XLR-3-32: -28 dBm (LINE level) or -58 dBm (MIC level) –
1/4-inch phone jack: -30 dBm
Monitor output connector 3.5 mm (5/32 inch) dia., stereo mini jack (x1) 1/4-inch stereo mini jack (x1) –
Monitor output level 5 mW (at 16 Ω) –
Indicators LCD Operating channel number/frequency, audio-output Operating channel number/frequency, audio-output status, RF-input level
status, RF-input level, tuner battery status, and
accumulated operating time
LED RF-input status
Power requirements DC 3.0 V (two AA-size alkaline (LR6) batteries) DC 9.0 V
Battery life Approx. 6 hours (with Sony AA-size alkaline (LR6) –
batteries at 25 °C (77 °F)
Dimensions (W x H x D) 63 x 100 x 30 mm 212 x 44 x 209 mm 56.6 x 25.5 x 121.0 mm
(2 1/2 x 4 x 1 3/16 inches) (8 3/8 x 1 3/4 x 8 1/4 inches) (2 1/2 x 1 1/16 x 4 7/8 inches)
Mass Approx. 180 g (6 oz) including batteries Approx. 1.3 kg (2 lb 14 oz) Approx. 150 g (5.3 oz)
Supplied accessories Microphone stand adaptor (x1)*, shoe-mount AC/DC adaptor (x1) –
adaptor (x1), belt clip (x1), output cable
(x2, 3-pole mini-plug/XLR-type, 3-pole
mini-plug/stereo mini-plug)
*Microphone stand adaptor is not included in the UWP-C3 package.
11
S P E C I F I C A T I O N S