Schumacher Automatic SWI-1555A - Manual (Page 38)

• 37 •
Attach the Foot: Remove the charger from the packing materials and
place upside down on a flat surface. Attach the foot and secure it with
the four ¼-20 thread cutting screws provided.
Assemble the Wheels and Axle: Hold the axle
upright on the floor or work surface. Then, using a
hammer, tap one of the axle caps onto the top end of
the axle. Be sure to tap the axle cap on straight. Slide
both wheels onto the axle with the recessed hubs
facing out as shown. Install the second axle cap.
Mount the
Axle to the Charger: Place one end of each
bracket into the slot on the bottom of the charger.
Place the axle assembly under each bracket.
Attach the brackets using the two, 10-32 thread
cutting screws provided.
NOTE: Be careful not to drop the brackets inside
of the charger case.
Attach the Handle: If the charger came with a plastic grip, slide
that onto the handle until it is centered at the top. Turn the charger
right side up onto its foot and wheels. Align the handle so the
screw holes are aligned with the screw holes on the upper back
corners of the charger. Attach the handle using the four Phillips
head screws provided.