Samsung Digimax S700 - Manual (Page 66)

ŝ65Ş
Software Notes About the software
System Requirements
Please ensure that you read the instruction manual carefully before use.
ҮThe attached software is a camera driver and image editing software tool for
Windows.
ҮUnder no circumstances should all or part of either the software or the user
manual be reproduced.
ҮCopyrights for software are licensed only for use with a camera.
ҮIn the unlikely event of a manufacturing fault, we will repair or exchange your
camera. We cannot, however, be held responsible in any way for damage
caused by inappropriate use.
ҮUsing a Hand-made PC or a PC and OS that has not been guaranteed by the
manufacturer is not covered by the Samsung warranty.
ҮBefore reading this manual, you should have a basic knowledge of computers
and O/S (Operating Systems).
After inserting the CD-ROM provided with this camera into the CD-ROM drive, the
following window should automatically run.
Before connecting the camera to the PC, you
should first install the camera driver.
ſScreen Captures illustrated on this manual is
based on English Edition of Windows.
ƃ Be sure to check the system requirements before installing the driver.
ƃ You should allow 5 ~ 10 seconds for running the automatic setup program
according to the capability of your computer. If the frame does not show, run
the [Windows Explorer] and select [Samsung.exe] in the CD-ROM Drive
root directory.
INFORMATION
For Windows For Macintosh
Windows 98 / 98SE / 2000 / ME / XP Mac OS 9.2 ~ 10.3
Minimum 64MB RAM Minimum 64MB RAM
200MB of available hard disk space 110MB of available hard-disk space
USB port USB port
CD-ROM drive CD-ROM drive
PC with processor better than Pentium II 450MHz
(Pentium 700MHz recommended)
1024x768 pixels, 16bit color display
compatible monitor
(24bit color display recommended)
Power Mac G3 or later
ƈ Camera driver : This enables images to transfer between the camera
and PC.
This camera uses the USB Storage Driver as the camera driver. You can use
the camera as a USB card reader. After installing the driver and connecting this
camera to the PC, you can find [Removable Disk] in [Windows Explorer] or [My
computer]. A USB Storage Driver is provided only for Windows. A USB Driver
for MAC is not included with the Application CD. You can use the camera with
Mac OS 9.2 ~ 10.3.
ƈ Digimax Master : This is the all-in-one multi media software solution.
You can download, view, edit and save your digital images and movie clips with
this software. This software is only compatible with Windows.