Sunfire Solitaire 12 - Manual (Page 8)

User's Manual
8
Control Panel Features continued
EURO (230 VAC) MODEL: Connect
the linecord to the subwoofer before
connecting the other end to a 230 Volt,
50/60 Hz AC outlet. The outlet must
have a cir cuit rating of 8 amps or more.
Never plug the Euro (230 VAC)
model subwoofer directly into 120-
130 Volts AC.
11. Power Switch
The power switch is a CE requirement
for international shipments. Leave it
switched on at all times for normal
operation.
After a period of inactivity (i.e. with
no input signal), the subwoofer will
automatically turn itself to Standby
mode, where it is effectively off. It can
however, turn back on automatically
when an input signal is applied, if a
12 VDC trigger voltage is applied to the
Trigger inputs, or if the Start button is
pressed.
12.Start button
Press this once to enter the Auto EQ
mode (if the sub is out of Standby
mode). Press and hold down for
several seconds to enter the Manual
EQ mode. See page 12 for more
details on this and the following EQ
controls.
13.Microphone Input
This is where you plug in the supplied
linear measurement microphone when
you want to use the Auto EQ mode.
14.LED display
These LEDs are used during the Auto
EQ and Manual EQ procedures.
15.Equalizer Authority
This control's primary purpose is to
adjust the EQ Authority. During normal
listening, you can adjust the overall EQ
from none (ccw, 0%), to fully equalized
(cw, 100%). For example, if your Þ rst
band has a 6 dB boost, setting this
control to 50% would make it boost
only 3 dB.
This control is also used during the
Manual EQ mode to adjust each of the
four internal EQ bands, and allow you
to add "color" to the sound as desired.
DIM - STANDBY
BRIGHT - ON
Solitaire 10
11
15
14
13
12