6 error messages – Star Micronics TUP482-24 User Manual
Page 18
– 14 –
6.6 Error Messages
It is possible to determine the type of error occurring by observing the printing results and which LED
lights up.
a) Recoverable errors
The printer goes off line when these errors occur.
To resume operation, remove the cause of the error, then press the RESUME button.
b) Unrecoverable errors
The printer goes off line when these errors occur.
Operation of the printer cannot be resumed even after the cause of the unrecoverable error is
removed.
c) Other errors
●
Data errors (<ESC> “PC” command: defines character and bar code data)
A data error will occur if an invalid character or bar code type is selected or if the print result
extends outside the print area. When a data error occurs, all commands become invalid (character
strings and bar codes are not printed). However, the printer will not go off line and the LEDs will
not light up.
Error
Cause
LED
ERR
HU
PE
Head up error
The head is raised.
On
Paper-out error
No paper is inserted.
On
Label size error
The paper size differs from the measured size.
On
Error
Cause
LED
ERR
HU
PE
Command error
There is an error in the command.
On
Cutting error
The paper is not cut properly.
On
On
Transmission error *1
There is an abnormality in the received data.
On
On
Paper jam error *2
The paper is not fed up to the sensor.
On
On
On
*1 Valid only with the serial interface
*2 Valid only in presenter mode