Star Micronics TUP482-24 - Manual (Page 19)

– 15 –
6.7 Near-End Sensor Position
<Technical Specifications>
The near-end sensors can be moved a maximum of 5 mm to the right or left by moving the near-end
sensor PCB.
Slightly loosen the three screws (without removing them) used to install the PCB, then move the PCB
to the desired position. After making sure that the PCB fits properly (i.e. it is not loose), tighten the
three screws. (Do not break the PCB.)
* The near-end sensors are mounted on the back of the PCB.
Near-end sensor PCB
Near-end sensor NEB
Near-end sensor NEA
Square hole
Side frame
Slot
Can be moved a maximum
of 5 mm to the right and left
Screw