Star Micronics TUP482-24 - Manual (Page 26)

– 22 –
11. POWER REQUIREMENTS
The input voltage shall be DC 24 V
±
7% (rated 2.5 A, less than 6 A/15 sec.). The current used when
solid printing is performed is shown below.
Item Specification
T (weld time) approx. 550 ms (25C, standard density)
Max. 800 ms depending on the conditions
Current (during solid
printing) Peak current: 12 A max.
Average current: 6.6 A max.
Item Specification
Recommended power
supply For 100 or 120 V Star Micronics Power Supply Unit SLS-060P-50
(Part number: 87393030)
For 230 V Star Micronics Power Supply Unit SLS060PH-50A
(Part number: 87393090)
12A
8A
T T
12A
8A
T T
0.5A 0.5A
Block 1 (384 dots)
Block 2 (256 dots)
Cycle 2.5ms
12
Ч
0.8 + 8
Ч
0.8 + 0.5
Ч
(2.5 – 0.8
Ч
2)
2.5