JVC KD-SHX751 - Manual (Page 47)

47
ENGLISH
To activate the Announcement Standby
Reception
1
Enter the MODE menu (see page 5).
2
Select “Announce.”
3
Select an announce type.
4
Finish the procedure.
ANN indicator appears.
• If the ANN indicator lights up,
Announcement Standby Reception is
activated.
• If the ANN indicator flashes,
Announcement Standby Reception is not
yet activated.
To activate, tune in to another service
providing these signals. The ANN
indicator will stop flashing and remain
lit.
To deactivate the Announcement Standby
Reception
Select “Off” in step 3 above.
The ANN indicator goes off.
Selected announcement type
When using the remote controller...
To directly select the preset service
Using the Standby Receptions
TA (Road Traffic News) Standby
Reception
• Operations are exactly the same as explained
on page 15 for FM RDS stations.
• You cannot activate TA Standby Reception
separately for the DAB tuner and for FM
tuner.
PTY Standby Reception
• Operations are exactly the same as explained
on page 15 for FM RDS stations.
• PTY Standby Reception for DAB tuner works
only using a dynamic PTY code.
• You can neither store your favorite PTY nor
activate PTY Standby Reception separately
for the DAB tuner and for the FM tuner.
• You can activate and deactivate PTY Standby
Reception when the source is either “FM” or
“DAB.”
Announcement Standby Reception
Announcement Standby Reception allows the
receiver to switch temporarily to your favorite
service (announcement type).
To select your favorite announcement type,
see page 39.
EN44-48_KD-SHX751[EY]f.indd 47 EN44-48_KD-SHX751[EY]f.indd 47 05.2.15 8:18:10 PM 05.2.15 8:18:10 PM