Spin Master Paint Sensation - Manual (Page 6)

1. Use a phillips screwdriver (not provided) to loosen the battery compartment door hold down screws.
Remove the battery compartment door.
2. Install four 1.5-Volt “C” alkaline batteries (not included). Be careful to align the positive (+) and (-) polarities with the
corresponding markings inside the battery compartment.
3. Replace the battery compartment door and refasten the screws.
4. Batteries are not included.
IMPORTANT BATTERY INFORMATION
• Battery installation and change of battery should always be performed by an adult.
• Be careful to install the batteries with the correct polarity as indicated.
• Do not mix alkaline, standard (carbon zinc), rechargeable (nickel cadmium or
nickel-metal hydrate) batteries.
• Different types of batteries or new and used batteries are not to be mixed.
• Use Alkaline batteries for better performance.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged
(if removable).
• Exhausted batteries are to be removed from the toy.
• Only batteries of the same or equivalent type as, recommended are to be used.
• The supply terminals are not to be short circuited.
• Do not mix old and new batteries.
• Products with non-replaceable batteries are not to be disposed of in a fire
as the batteries inside may explode and leak.
• Dispose of batteries safely.
• Do not use rechargeable batteries.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Web: www.spinmaster.com Email: [email protected]
Manufactured for and distributed by Spin Master Ltd.
Conforms to safety standards ASTM F963-03, ASTM D-4236 & EN71,
Regulatory Requirements. Products and colors may vary. MADE IN CHINA.
Item #70658 US-ENG-70658-IS-5
Paint is not coming out when I press the
Paint Button.
Paint is dripping onto my creations.
The paint comes out too fast.
I can’t make my designs look
like swirls.
Paint SensationTM has no power.
I can’t get water out from inside the Arm
Cover after it has been washed.
Cleaning Tool button will not depress.
• The Paint Canister does not have enough paint in it. Refill with fresh paint.
• The Paint Canister holes are blocked. Read the section on Cleaning Tool
under Cleaning Paint Canisters in these instructions.
• Paint can build up in the Arm Cover after frequent use. Remove
the Arm Cover and rinse with warm soapy water. Reattach to the Paint Arm.
• Try pulsing the Paint Button
• Slow down how fast you are moving the Control Arm back and forth.
• Make sure the ON/OFF button is in the ON position.
• Batteries may need replacing. Ask a parent to replace the batteries.
• Shake out as much water as possible after cleaning. Residual water will
evaporate and will not affect the toy’s performance.
• The Half Moon Tool Guide has not connected with the Tool Guide inside the
Cleaning Tool. Reposition and reinsert until the Cleaning Tool Button
depresses.
TROUBLESHOOTING
BATTERY INSTALLATION
Battery Compartment
Four
1.5-Volt
“C”
Batteries
Battery
Compartment
Door
Paint-Sensation ™
turned over to access the
Battery Compartment
CAUTION: Changes or modifications to this product not expressly approved by party responsible for compliance may
void the user’s authority to operate the equipment. This product may stain or stick to some surfaces. Protect play area
before use. Use damp cloth with warm water and soap to remove stains from clothing, carpeting and other surfaces that
the item is likely to come in contact with. SAFETY TESTED. Remove all packaging material before giving the toy to your
child. Please retain this information for future reference.