Installing the water dispenser line, Connect to the water supply line, For exterior model – Samsung da99-00494v User Manual

Page 32

Advertising
background image

32

INSTALLING THE WATER DISPENSER LINE

Remove any residual matter inside the purifier. (Model with the purifier)

- Open the main water tap to check whether water

is running through the water tube on the water

inlet side of the purifier.

- If water does not come out through the line,

check whether the tap is open.

- Leave the tap open until clean water is running

out and any residual matter that built up during

manufacturing has been removed.

- If you wish to reassemble the water inlet

and outlet sides of the purifier during purifier

installation, see the reference illustration.

Select the location where the purifier is to install. (Model with the purifier)

- Cut the water line attached to the purifier

to the appropriate place after measuring

the distance between the purifier and the

cold water tap.

COUPLER

SIDE OF

PURIFIER

WATER LINE

PURIFIER

WATER

OUTLET SIDE

OF PURIFIER

WATER INLET

SIDE OF PURIFIER

LINE OUTLET

90 degree

PURIFIER

WATER

REFERENCE

WARRANTY INFORMATION
This water line installation is not covered by the refriger-ator
or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.

Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.

Connect to the water supply line

Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every join should be protected with sealing tape.

COUPLER “A”

TAP

CAUTION

The water line must be connected

to the cold water pipe.

If it is connected to the hot

water pipe, it may cause the

purifier to malfunction.

For Exterior model

DA99-00494V (EN)-0.1 9/20/04 10:17 AM Page 32

Advertising