Sony BDV-IT1000ES - Manual (Page 95)

O
the
r O
p
erati
ons
95 US
Using the Control for
HDMI Function for
“BRAVIA” Sync
This function is available on TVs with the
“BRAVIA” Sync function only.
By connecting Sony components that are
compatible with the Control for HDMI function
with an HDMI cable (not supplied), operation is
simplified as below:
– Theater Mode (page 96)
– One-Touch Play (page 96)
– System Power Off (page 97)
– Volume Limit (page 97)
– System Audio Control (page 97)
– Language Follow (page 97)
Control for HDMI is a mutual control function
standard used by CEC (Consumer Electronics
Control) for HDMI (High-Definition
Multimedia Interface).
The Control for HDMI function will not work in
the following cases:
– When you connect this system to a
component which is not compatible with the
Control for HDMI function.
– A component does not have an HDMI jack.
There are convenient buttons on the system’s
remote for operating the TV, such as
THEATER, ONE-TOUCH PLAY, AV "/1. For
details, see “Controlling the TV or Other
Components with the Supplied Remote”
(page 101) and refer to the operating
instructions of the TV.
Note
• Depending on the connected component, the Control
for HDMI function may not work. Refer to the
operating instructions supplied with the component.
• The Control for HDMI function may not work if you
connect a component other than Sony, even if the
component is compatible with the Control for HDMI
function.
(Control for HDMI - Easy Setting)
The system is compatible with the Control for
HDMI - Easy Setting function. If the TV is
compatible with the Control for HDMI - Easy
Setting function, you can set the system’s
[Control for HDMI] function automatically by
setting the TV. For details, refer to the operating
instructions of the TV.
If the TV is not compatible with the Control for
HDMI - Easy Setting function, set the Control
for HDMI function of the system and TV
manually.
Note
• Displayed items vary depending on the country
model.
1
Make sure that the system is
connected to the TV and the connected
components (which should be
compatible with the Control for HDMI
function) using HDMI cables.
2
Turn on the TV and press [/1 to turn on
the system.
3
Switch the input selector on your TV so
that the signal from the system through
the HDMI input appears on the TV
screen.
4
Set the Control for HDMI function of the
system and TV.
The Control for HDMI function for the
system and the connected component is
simultaneously set to on.
During the setting, “SCANNING” appears
in the panel display. After you finish the
setting, “COMPLETE” appears in the panel
display. Wait until the setting is complete.
Other Operations
3 2 1
3 2 1
THEATER
OPERATION CHANGE
STB TV BD
AV
BRAVIA Sync
ONE-TOUCH
PLAY
Preparing for the Control for
HDMI function