JVC SP-F303E - Manual (Page 3)

English 5 Assembling the satellite speakers
Each speaker (except the center speaker) has been divided
into two parts for shipment. Before using this speaker system,
assemble it first by following the procedure below.
• Prepare a Phillips screw driver.
Before assembling—
• Take care not to drop the stand while assembling;
otherwise, it may cause damage to the floor or injury.
• Ensure enough space for assembly and installation.
• Place a large, thick cloth on the floor where you
assemble the speaker, so you can protect the floor and
the speaker itself.
• Use the speaker only after assembly is fully and
correctly done.
1
Connect the speaker connecters to the
stand connecters.
2
Join the stand to the speaker section.
3
Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Cushion (not supplied)
Assembly
Speaker
section
Stand
To be continued on the next page
It is recommended to place a cushion under the speaker
section.
• You can tighten the screws easily by placing the
speaker section horizontally.
Speaker section
Stand
Screw (4)
(Supplied, M4 x 25 mm)
Rear
Front
Front
Speaker connectors
Speaker section
Speaker section
Stand
Stand
– 2 –
#SP-F303-E-EN.p65 02/03/3, 2:58 pm 3