Sanyo SRP-270 - Manual (Page 14)

Serial Interface (RS-232C/RS-485) Specification
DIP Switch 1 Setting
Emulation mode selection
Dip Switch 2 Setting
Baud rate selection
NOTE : When the word length is 7 bits, you can not parity check OFF status.
SW FUNCTION ON OFF DEFAULT
1 OFF
2 Emulation
Selection
Refer to the following table
OFF
3 Auto-Cutter Enable Disable OFF
4 FONT SPACE 2 3 OFF
5 -
6 -
7
Function for
service
Engineer OFF
8 RESERVED OFF
SW – 1 SW – 2 MODE
OFF OFF Epson
OFF ON Citizen
ON OFF Star
SW FUNCTION ON OFF DEFAULT
1 Data Receive Error Print ”?” Ignore OFF
2 Hexadecimal dump YES NO OFF
3 Hand Shaking XON/OFF DTR/DSR OFF
4 Word length 7 bits 8 bits OFF
5 Parity check Enable Disable OFF
6 Parity selection EVEN ODD OFF
7 OFF
8 Baud Rate
selection
Refer to the following table
OFF
Transmission speed SW – 7 SW – 8
1200 baud ON ON
2400 baud OFF ON
4800 baud ON OFF
9600 baud OFF OFF