Connecting the ac power cord (mains lead) – Sony DAV-C700 User Manual

Page 24

Advertising
background image

24

IN

IN

OUT

OUT

OUT

IN

VIDEO

OUT

R

VIDEO

IN

AUDIO

OUT

AUDIO

IN

L

VIDEO

OUT

R

AUDIO

OUT

L

OUTPUT

VIDEO

IN

INPUT

OPTICAL

V I D E O O U T

A U D I O OUT

V I D E O I N

A U D I O I N

L

R

V I D E O I N

A U D I O I N

L

R

V I D E O

S V I D E O

( DVD ONLY)

Y

P

B

/ B - Y

P

R

/ R - Y

FRONT R

FRONT L

CENTER

S P E A K E R

REAR R

REAR L

WOOFER

COAXIAL

AM

FM

75

VIDEO 1

MONITOR OUT

COMPONENT VIDEO OUT

COMPOMENT

VIDEO IN

Y

P

B

/ B - Y

P

R

/ R - Y

O P T I C A L

D I G I T A L

I N

D I G I T A L

( C D O N L Y )

DIGITAL

OUT

If you connect a digital satellite receiver with the OPTICAL jack

The digital satellite receiver can be connected to the OPTICAL jack instead of the VIDEO IN
and AUDIO IN L/R jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over
analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.

If you connect a digital satellite receiver without the OPTICAL jack

Connect the digital satellite receiver to the VIDEO IN and AUDIO IN L/R jacks only of the
system.

Setup for the system (for Asian and Australian models)

Setup is necessary for the system, depending on the TV monitor to be connected.
The initial setting for Asian models is NTSC but Australian models is PAL.

If the colour system of the TV is PAL

*

To set the system to PAL, turn on the system by pressing 1 (power) on the remote while
pressing X (pause) button on the system. You need to hold the X button until DAV-C700
appears on the display. To reset to NTSC, turn off the system and then turn on again using the
remote while pressing the X button on the system.
* If the colour system of the TV is NTSC, do the same operation above to set the system to

NTSC.

Connecting the AC Power Cord (mains lead)

Before connecting the AC power cord (mains lead) of this system to a wall outlet (mains),
connect the speakers to the system (see page 18).
Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).

VCR

Digital satellite receiver

TV monitor

Equipment with component
video input jacks

Advertising
This manual is related to the following products: