Speco Technologies HT-INTD3 - Manual (Page 20)

Troubleshooting
● Have you set the ‘MOTION DET.’ menu to off?
● Have you set ‘MD LEVEL’ to too low?
● Have you set ‘MD ARAEA’ properly
MOTION DETECTION
function is not active.
● Check that you have properly connected
the camera to an appropriate power source.
The camera is not
working properly,
and the surface of
the camera is not.
● Adjust the contrast feature of the monitor.
● If you have an intermediate device, set the
75Ω/Hi-z properly.
The image on the
screen is dark.
● Is the lens stained with dirt? Clean your lens with a
soft, clean cloth.
●
Adjust the monitor controls.
● If the camera is exposed to a strong light
change the camera position.
● Adjust the lens’ focus properly.
The image on the
screen is dim.
● Check that the power cord and line connection
between the camera and monitor are attached.
● Check that you have properly connected your video
cables.
Nothing appears on
the screen.
Solution Problem
● Have you connected your camera to DC power
source? Connect it to AC power source.
L/L mode cannot
be selected.
● Is the camera facing direct sunlight or
fluorescent lighting? Change the camera position.
The image on the
screen flickers.
● Check that you have properly set the ‘WHITE
BAL’ menu
The color of the
picture is not
matched.
Solution Problem
If you have trouble operating your camera, refer to the following.
36 35