Shindaiwa HomePro 41RS Broadcast - Manual (Page 7)

MAINTENANCE
WARRANTY
Never store unused material in spreader.
1.
Return unused product to its original container.
Wash spreader thoroughly after each use 2.
and dry completely in sun or heated area.
Oil the axle bearings, impeller shaft bearing 3.
in hopper, control knob in T-handle.
Remove gear cover and wash gears
4.
thoroughly. Oil all bearing areas and face
of gear teeth. Re-install gear cover.
Gear mesh should be checked on a regular 5.
basis during high use periods. Clearance
between the axle gear and pinion gear should
be minimal but not tight. If adjustment is nec-
essary, loosen axle collar set screw and hold
gears together. Slide axle collar against the
gear support and tighten axle collar set screw.
Spin drive wheel. Gears should run freely and
smoothly.
Impeller surface should be cleaned periodically 6.
to remove build-up of product. Build-up can
cause the spread pattern to change.
Tire pressure should be 20-25 PSI. 7.
Shindaiwa Inc. manufactures its products to superior standards of quality to ensure customers obtain the highest level of satisfaction. In
keeping with this goal, Shindaiwa Inc. warrants the unit to the original purchaser as follows:
WARRANTY PERIOD
One year from the delivery date to the original purchaser for consumer and commercial applications.90 days for rental applications.
WARRANTY ADMINISTRATION
Within the covered warranty period, Shindaiwa Inc. will, at their option, repair or replace any defect in material or workmanship, without
charge for parts or labor, if this product is presented at an authorized Shindaiwa dealer.
WARRANTY EXCLUSIONS AND LIMITATIONS
Shindaiwa Inc. assumes no responsibility for damages, loss, or injury resulting from:

Normal wear and tear
 Misuse or neglect
 Modifications to or removal of original component parts
The warranty is limited to the terms stated herein. Shindaiwa Inc. disclaims all liability for incidental or consequential damages. Some
states do not allow the exclusion of incidental or consequential damages, so these limitations may not apply to you.
This warranty give you specific legal rights, and you may also have other rights which may vary from state to state.
Shindaiwa reserves the right to change the design or specifications of this product without obligation to modify previously manufactured
products.
OWNER’S RESPONSIBILITIES
The owner of the unit must demonstrate reasonable care in the use, maintenance, and storage of this Shindaiwa product. If a warrant-
able failure should occur, the owner must deliver the product to an authorized Shindaiwa servicing dealer for correction. All residual chem-
icals must be flushed from the tank prior to delivery.
Unidentified chemicals left in the tank can pose a serious health threat to anyone servicing the unit and unaware of its
presence!
To obtain warranty service, proof of purchase must be presented to the authorized Shindaiwa servicing dealer when the product is
presented for repairs.
Proof of purchase must include date of purchase and the name and address of the selling dealer.
Oil
Oil Impeller Shaft
Bearing In Hopper
Oil
Oil
Axle Collar