Sirius Range Hoods SU1 - Manual (Page 8)

Connecting Chimneys
Remove the protective covering from
the decorative chimney and carefully
slide the sections together.
Do not remove the tape strips from
inside the chimney as this protects
the telescoping chimney-piece
from scratching.
Holding the two chimney sections
together carefully position them over
the ductwork and
wiring. Position
the upper chim-
ney so that it can
be fixed via the
holes on the side
of the ‘Y” bracket
on the ceiling
(refer to Figure
10).
Please refer to the Electrical Supply
section on page 2 for the required
location of the electrical supply.
CAUTION: Make sure the power is
turned off at source. Make electrical
connections (refer to Fig 7).
Ensure that the plastic flaps at the
exhaust outlet for the fan move
freely and have not become jammed
or stuck.
Connect the appropriate length of
ducting to the fan exhaust point and
join up with the ducting to the
exterior. Figure 8 shows venting
directly through the wall. Venting up
and through the ceiling to the exte-
rior is also possible (refer to Fig 9).
Do not fix the ducting to the range
hood exhaust outlet with screws -
use duct tape. Use duct tape on all
joints.
Figure 9
Figure 10
Figure 8
Connecting Electricity and Ducting
Figure 7
5