Sanyo PJLINK PLC-ZM5000L - Manual (Page 48)

Use the Point ◄► buttons to adjust the gamma value
to obtain a better balance of contrast (from 0 to 15).
Press the Point ◄ button to decrease the sharpness
of the image; press the Point ► button to increase the
sharpness of the image (from 0 to 31).
An interlaced video signal can be displayed in
progressive mode. Press the Point ◄► buttons to
change the progressive scan mode.
Off ............. Progressive scan mode is Off.
On ............. Progressive scan mode is On .
Film ........... For watching a film. With this function,
the projector reproduces pictures faithful
to the original film quality.
Noise interference on the screen can be reduced.
Press the Point ◄► buttons to change the noise
reduction mode.
Off ............. Noise reduction mode is Off.
On ............. Noise reduction mode is On.
 Note:
• Progressive cannot be selected when 480p,
575p, 720p, or 1080p is selected (p.45).
• Noise reduction cannot be selected with the
computer input and when the video signal format
is 1080p (p.45).
To reset the adjusted data, select Reset and press
the SELECT button. A confirmation box appears and
then select yes. All adjustments will return to their
previous figures.
To store the adjusted data, select Store and press
the Point ► or the SELECT button. Use the Point
▲▼ buttons to select one from Images 1 to 10 and
press the SELECT button.
A confirmation box appears and then select yes.
Stored data can be called up by selecting an Image
(1-10) in the Image Mode Selection on page 46.
A confirmation box appears
and then select yes.
Store
Video Input
Press the Point ◄ button to lighten red/green/blue tone
of the black level of an image; press the Point ► button
to deepen red/green/blue tone of the black level of an
image (from 0 to 63).
Offset (Red/Green/Blue)
Sharpness
Gamma
Noise reduction
Progressive
Reset
Store
48