Sanyo PJLINK PLC-ZM5000L - Manual (Page 69)

Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Loosen the screws and open the lamp cover. Loosen
3 screws of the lamp and pull out the lamp by using
the built in handle.
1
3 Replace the lamp with a new one. Make sure that the
lamp is properly and fully inserted.
4
2
Connect the AC power cord to the projector and turn
on the projector.
Follow these steps to replace the lamp.
5
 Note:
Be sure to insert the lamp in the correct direction.
For continued safety, replace with a lamp
of the same type. Do not drop the lamp
or touch the glass bulb! The glass can
shatter and may cause injury.
Allow a projector to cool for at least 45 minutes before
you open the lamp cover. The inside of the projector can
become very hot.
CAUTION
CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on
the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The
timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon

Note:
The Lamp replacement icon will not appear when the
Display function is set to Off (p.52) or during “Freeze”
(p.30)
Close the lamp cover and secure the screw.
Maintenance and Care
Lamp Replacement
When replacing the lamp because it has stopped
illuminating, there is a possibility that the lamp may be
broken.
If replacing the lamp of a projector which has been
installed on the ceiling, you should always assume that
the lamp is broken, and you should stand to the side of
the lamp cover, not underneath it. Remove the lamp cover
gently. Small pieces of glass may fall out when the lamp
cover is opened.
If pieces of glass get into your eyes or mouth, seek
medical advice immediately.
CAUTION
Lamp
Handle
Lamp cover
Screw
New
Lamp
Screws
69