Siemens MCM 1755 NTD - Manual (Page 25)

Color monitor MCM 1755 NTD
A26361-K472-Z100-2-5E19 English - 17
Setting picture size, position, edges and color temperature
The picture size, position and edges have been set to optimum values at the
factory for the preset operating modes (see "Technical data"). Depending on the
monitor controller used, it may be necessary to change these settings. In this case
you should change the settings.
You can change the colors by specifying a different color temperature.
The monitor can store up to 18 different display modes (including the predefined
operating modes).
To make a setting, perform the following steps:
Ê Press the button for the function you want.
A window representing the function selected will then appear on the screen. The
power lamp glows amber. While the power lamp is glowing amber the arrow
buttons for the selected function are active.
Ê Press the arrow buttons ( , , or ) until you have achieved the result
you require.
All modifications are automatically stored if no button is pressed for several
seconds. The window on the screen is then masked out and the power lamp once
again glows green.
Adjusting the horizontal or vertical position
Press the Position button once.
Use the
or button to shift the picture to the left or right.
Use the or button to shift the picture up or down.
Adjusting the horizontal or vertical size
Press the Size button once.
Use arrow button
or to adjust the horizontal picture size.
Use the or button to adjust the vertical picture size.
Correcting cushion-shaped, barrel-shaped or trapezium
distortion
Press the Picture edges button once.
Use arrow button
or to correct the cushion-shaped or barrel-
shaped distortion.
Use the
or button to correct trapezium distortion.
Correcting tilt or parallelogram distortion
Press the Picture edges button twice.
Use arrow button
or to correct the parallelogram distortion.
Use the or button to correct the tilt distortion.