Samsung RB197** - Manual (Page 11)

setting up _11
instaLLation of tHE watER LinE
Before you install the water line
• The water line installation is not warranted by the refrigerator manufacturer.
So before you install the water line, read the whole steps for installing and follow these instructions
carefully to minimize the risk of expensive water damage.
• Banging pipes (water banging in the pipes) in house plumbing can cause damage to fridge parts and
lead to water leakage or flooding. Call a qualified plumber to correct the problem before installing the
water supply line to the fridge.
• To prevent burns and product damage, do not hook up the water line to the hot water line.
• Do not install the water line in areas where temperatures fall below freezing.
• When using any electrical device (such as a power drill) during installation, be sure the device is
insulated or wired in a manner to prevent electric shock.
• All installations must be in a accordance with local plumbing code requirements.
Connecting to water supply line
• Shut off the main water supply line and turn the Ice maker to
the off position.
• Locate the nearest cold drinking water line.
• Follow the instructions in the water filter installation kit.
• After connecting the water supply line to the Cartridge Holder
inlet and installing the Filter Cartridge (insert plastic line in
fully).
• Turn on water supply and Flush 3 gallons through filter before
use (flush approximately 6 minutes)
• Water line Kit and water filter are not covered by Samsung’s Warranty. The manufacturer (or dealer,
installer) of them is responsible for any defects and all the loss caused by water filter & water line kit .
• The filter should be replaced should be replaced according to manufacturer (or dealer)’s instruction.
• To order additional water filters, please contact the manufacturer (or dealer) of the filter.
• The water filter must be installed outside the refrigerator.
It is not provided with your new refrigerator. The filter cartridge
(
8) and holder (9) kit can be purchased from the retailer where
you purchased this refrigerator.
• Do not use copper line.
• Cut the tubing, making sure the ends are square and clean.
01
s
E
tting
u
P
90 degree
1. Cold water line
2. Pipe Clamp.
3. Plastic line
4. Compression nut
5. Compression sleeve
6. Packing nut
7. shut off Valve
8. filter Cartridge
9. Cartridge Holder
using the water filter (not provided)
Incorrect Correct
DA68-01778A-07.indd 11 2010.4.9 3:32:14 PM