Sony D-SJ301 - Manual (Page 21)

21
Troubleshooting
Should any problem persist after you have checked these symptoms, consult your nearest Sony
dealer.
Symptom
The volume does not increase
even if the VOL control is
adjusted to the maximum
level.
No sound, or noise is heard.
The playing time is too short
when powered with the dry
batteries.
The playing time is too short
when powered with the
rechargeable batteries.
“Lo batt” or “00” appears in
the display. The CD does not
play.
“HI dc In” appears in the
display.
The CD does not play or
“no dISC” appears in the
display when a CD is placed
in the CD player.
“Hold” appears in the
display when you press a
button, and the CD does not
play.
The CD player does not start
charging.
Cause and/or corrective actions
c If “AVLS” appears in the display, hold down SOUND until
“AVLS” disappears from the display. (page 13)
c Connect the plugs firmly. (page 6)
c Plugs are dirty. Clean the plugs with a dry soft cloth periodically.
c Check that you are using alkaline batteries and not manganese
batteries. (page 18)
c Replace the batteries with new LR6 (size AA) alkaline batteries.
(page 18)
c Charge and discharge the rechargeable batteries several times.
(pages 16, 17)
c The rechargeable batteries are used up completely. Charge the
batteries. (pages 16, 17)
c Replace the batteries with new LR6 (size AA) alkaline batteries.
(page 18)
c Use only the AC power adaptor or car battery cord in “Accessories
(supplied/optional).” (back cover)
c Remove all power sources, then insert the batteries or connect the
AC power adaptor again. (pages 6, 16, 17, 18)
c The buttons are locked. Slide the HOLD switch back. (page 13)
c The CD is dirty or defective. (page 19)
c Check that the CD is inserted with the label side up. (page 6)
c Moisture condensation has occurred.
Leave the CD player aside for several hours until the moisture
evaporates.
c Close the lid of the battery compartment firmly. (page 16)
c Make sure the batteries are inserted correctly. (pages 16 - 18)
c Connect the AC power adaptor to an AC outlet securely. (page 6)
c The CD-R/CD-RW was not finalized. Finalize the CD-R/CD-RW
with the recording device.
c There is a problem with the quality of the CD-R/CD-RW,
recording device, or application software.
c The buttons are locked. Slide the HOLD switch back. (page 13)
c During stop, press x/CHG. (page 16)
Additional information
(Continued)