Sony F500 - Manual (Page 50)

50 GB
Controlling Your TV with
the Supplied Remote
By adjusting the remote signal, you can control
your TV with the supplied remote.
Note
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
Press and hold TV [/1 while entering your
TV’s manufacturer’s code (see the table)
using the number buttons. Then release TV
[/1.
If the setting is unsuccessful, the currently
registered code is not changed. Re-enter the
code number.
Code numbers of controllable
TVs
If more than one code number is listed, try
entering them one at a time until you find the
code that works with your TV.
Saving Power in Standby
Mode
Check that the following settings in [System
Settings] are made:
– [Control for HDMI] in [HDMI Settings] is set
to [Off] (page 45).
– [Quick Start Mode] is set to [Off] (page 55).
Preparing the remote for
controlling the TV
Manufacturer Code number
SONY 01 (default)
SAMSUNG 02, 08
LG 05
PHILIPS 02, 03, 07
PANASONIC 06
TOSHIBA 04