Sennheiser Work Light - Manual (Page 5)

Mounting AudioBeam
1 4
Mounting AudioBeam
Correct mounting location
Warning!
Failure to comply with the following location conditions may result in
danger to persons and damage to AudioBeam!
When mounting AudioBeam, make sure that:
! the ultrasonic sound wave can travel undisturbed for at least 1 m before
it strikes the first surface.
! the sound (including the reflections) can travel for at least 4 m before it
strikes a human being
! a minimum distance of 10 cm is maintained between AudioBeam and
adjacent objects so that any heat generated can dissipate. Make sure
that the air vents at the top and rear of the unit are not covered or
blocked!
! a minimum distance of 1 meter is maintained between AudioBeam and
combustible materials
! AudioBeam is kept away from heat sources such as central heating
radiators, spot lights and lamps. Never expose AudioBeam to direct
sunlight.
! AudioBeam never gets damp or wet
Mounting AudioBeam in a fixed position
To ensure that AudioBeam is always orientated towards the correct area
of interest, you should mount AudioBeam fixedly. Use a mounting plate for
wall or ceiling mounting. For free installation, use a table or floor stand
(see: „Accessories“ on page 16).
̈
Screw the mounting plate or the table or floor stand to the
5 /
8
"
thread
¶
. If necessary, use the interchangeable thread to do this.
̈
By using a gooseneck or swivel joint (see: „Accessories“ on page 16),
directly orientate AudioBeam towards the correct area of interest or
the reflection area.
Mounting AudioBeam movably or rotatably
̈ Screw AudioBeam onto a drive mechanism or a rotating mechanism
using the
5 /
8
"
thread
¶
. Use the interchangeable thread if necessary.
̈
Start up AudioBeam as described on page 15 and ensure that the
distance sensor does not trigger in rotating mode (LED operation
indicator
³
is constantly lit green).
If the distance sensor triggers (LED operation indicator
³
lights up red):
̈
Remove all objects from the rotating range scanned by AudioBeam up
to a distance of 4m.
If the distance sensor still triggers (LED operation indicator lights
³
up red
again), you must turn off the built-in distance sensor as follows:
INPUT OUTPUT OVERLOAD
¶
³