Samsung SP-P410M - Manual (Page 31)

3-5 Using
3-5-3. Setup
Position Adjust the screen position if it is not aligned.
You can only set a position in <PC> mode.
Digital NR When a dotted line is displayed or the screen shakes , you can view the picture with better visual qual-
ity by enabling Noise Reduction.
Black Level If the picture seems too bright, you can set a darker black level.
Black level is automatically set in the <Video> input mode.
You can make the manual settings shown below only when a component signal is supplied.
• <0 IRE> : Default black level.
• <7.5 IRE> : Set the black level so it is darker.
Film Mode Using this function, you can set the display mode optimized for playing movies.
<Film Mode> provides optimal display settings for movies.
You can only set <Film Mode> in <Video> mode.
• <Off >-<On>
PC Eliminates or reduces noise that causes unstable screen quality, such as screen shaking. If the noise
is not removed using Fine Adjustment, adjust the frequency to the maximum and then perform Fine
Adjustment again.
Only activated in the PC environment. (component signals are not supported)
• <Auto Adjustment > : Used to adjust frequency and phase of PC screen automatically.
• <Coarse > : Used to adjust frequency when vertical lines appear on PC screen.
• <Fine> : Used to fine tune the PC screen.
• <Reset > : Using this function, you can reset the PC menu settings to the factory default settings.
Zoom Used to zoom in on the PC display screen.
Only activated in the PC environment.
MENU DESCRIPTION