SIIG 04-0621A - Manual (Page 4)

1
2
3
4
5
6
7
Figure 2
1
2
3
4
Figure 3 Figure 4 Figure 4-1
Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on
the back of the display (Figure 3).
Note: The concrete anchors must be used for concrete and brick installation.
Determine which screw (A/B/C/D/E/F) is of the correct length by carefully inserting a straw or toothpick, and
mark how deep the mounting point is (Figure 4 & 4-1).
Begin by placing the wall plate into position against the wall, using the
bubble level to keep it level. Locate the holes directly into the block or
concrete, never into the mortar between the blocks (Figure 2).
Step 2 Display Plate Installation
Drill six holes using an electric drill and 1/2" masonry bit to a depth of
2" at the positions you marked.
If necessary, a hammer can be used to lightly tap each concrete
anchor into place so that they are flush with the wall.
Insert bolts (H) and washers (J) into the concrete anchor as shown
(Figure 2) and tighten. Do not fully tighten until all screws are in place.
b) Concrete / Brick Installation
Insert a concrete anchor (G) into each hole.
Once all of the concrete anchors are in place, move the wall plate
back into position.
If your display has a curved back or a recessed thread mounting point, a spacer (K) must be used. Then
choose screw (D/E/F) to match. Place the spacer (M) between the mounting bracket and display (Figure 4-1).
According to the size of display's hole, choose the corresponding screw (A/B/C/D/E/F) and hole on the
rectangular washer (I), then thread them in line (Figure 4 & Figure 4-1).
Note: The installation kit includes screws of various diameters and lengths to ensure optimal installation.
Mark six holes to be used for securing the mount and place the wall
plate aside.
4