Sunpentown Intl WA-7500M - Manual (Page 6)

Before Use
4
Fig. 2
Fig. 1
Operation - Mechanical Models
9
Setting the Temperature
Turn the THERMOSTAT to regulate the temperature you desire: range 64 °F to 90°F.
Setting the Timer
Turn the TIMER to the desired operating time (1 to 8 hours).
When the set time has elapsed, the machine will shut off automatically.
Regulating the Airflow Direction
Turn the roller on the air vent to control
the airflow direction from the vertical louvres.
NOTICE!
• The compressor will start approximately 3 minutes after the unit is turned on
(this will help prolong the life of the compressor). After switching the unit off,
please wait at least 3 minutes before turning the unit back on.
• The cooling system will switch off if the room temperature is lower than set.The fan, however,
keeps working at the set level. If the ambient temperature rises above the chosen level +5 °,
the cooling will resume.
Important!
• Transport the unit in an upright position only, or leave it in
an upright position for at least 2 hours before first use.
• Always place the unit on an even surface (Figure 1).
• Make sure the unit is connected to a correctly grounded power supply
(refer to the rating label located at the back of the unit).
• An opening in a window or wall is required to accommodate
the exhaust hose (kit supplied) to expel the warm air.
• Do not cover or obstruct the appliance inlet or
outlet grilles (Figure 2).
• To avoid the risk of shock, the product should never be used
in bathrooms, shower rooms or in any other steamy or wet areas.
• The unit will cool when the room temperature is between
64 °F and 110°F depending on the thermostat setting.
• Do not sit or place objects on the unit.
• Do not touch the unit with wet/damp hands or
when standing barefoot.
• Avoid all contact with chemical based materials.
• The filter must be used with the product at all times. When removing
for cleaning, always disconnect the unit from the mains first.
• Turn off the appliance when not in use.
• At the end of each season all water must be drained and the unit
and filters cleaned before storage.
• Drainage of the water container is required before moving
the unit or putting it into storage.
• If the electric socket is different from the plug provided, have a
professionally qualified electrician replace the plug with a suitable one.
Avoid the use of adaptor plugs, multiple sockets and/or extension leads;
if their use is necessary, ensure that they conform to the
current safety regulations.
• Do not pull the supply cable or place it near a source of heat;
always unroll it completely to avoid the possibility of dangerous overheating.
• If the supply cord is damaged, it must be replaced by the
service agent or a similarly qualified person.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IF THE
ABOVE INSTRUCTIONS ARE NOT FOLLOWED.