Samsung SW51ASP - Manual (Page 6)

• Open the lid of the machine, pour water into the tub up to the level
just below the pulsator, and adjust the legs so that the pulsator is
positioned at the center of the water as shown in the figure.
• Place the machine more than
10cm away from the wall.
• Adjust the legs on feet
for levelling .
5
CLEANING THE FILTER NET
1.Push the upper part of
the filter and pull in.
2.Open the cover as
shown in the figure.
3.Clean the filter. 4. Close the cover and insert the lower
part of the filter in the basket first and
then push the filter with "click" sound .
1. Place a rag under washer filter not to wet the floor.
2. Turn the filter-cap to the left.
3. Take out the filter and remove any sludge.
4. Reassemble in reverse order.
CLEANING THE FILTER
(pump drained washer)
• When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch into
the Softener Inlet.
• Using too much softener may produce
unsatisfactory results.
• Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
• Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
HOW TO ADD THE FABRIC SOFTENER
1. Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in
the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
CAUTION : If softener is stored over the above base line, it may flow down at any time.
• If the washer is not leveled with the ground, it makes the machine
tremble more or be out of order. So, make sure that the washer is
leveled properly.
LEVELLING
Lock Loosen
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
Water