Sharp 27N S50 - Manual (Page 29)

29
L BLUE SCREEN
Automatically turns the screen blue if a broadcast signal is not received.
1
Press MENU to access MAIN MENU screen.
2 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to
“SET UP”.
3
Press VOL (+) or (–) to access SET UP mode.
4
Press VOL (+) or (–) to access BLUE SCREEN select mode.
5
Press VOL (+) or (–) to select “ON”.
Set Up (Continued)
2.4
Press MENU to exit.
• If you press VOL (+) again while in the CH SEARCH mode, auto-program will start again, and the
previously memorized channels will be lost.
→
(MAIN MENU screen)
(SET UP mode)
(BLUE SCREEN select mode)
VOL (+)
To add channel 12 to the
TV memory
VOL (–)
To erase channel 12 from
the TV memory (CH MEMORY
memorized channel)
(CH MEMORY
unmemorized channel)
NOTE:
VOLUME
(+)/(–)
CHANNEL
UP (
8 )/
DOWN ( 9 )
MENU
REMOTE
KEYPAD
6
Press MENU to exit.
• Poor reception due to weak signals, or too much noise might activate the BLUE SCREEN function
despite the presence of a broadcast signal. To continue watching TV under these conditions, switch
the BLUE SCREEN “OFF”.
• While VCR input mode is selected, the BLUE SCREEN will not be shown on your TV even if the
BLUE SCREEN is turned on.
NOTE:
26-29 27N-S50 6/1/00, 11:44 AM 29