Snapper 1691852 - Manual (Page 2)

INSTALLATION
1. Jack up rear frame and support rider with
wooden blocks or jackstands.
2. If 60 gallon grass catcher is to be installed,’
remove weights and mounting hardware from
rear frame. Retain hardware and reinstall
whenever grass catcher is removed.
3. Remove plastic cap (A, figure I), cotter pin (B),
and washers (C) securing rear wheel. Retain
h a r d w a r e t o r e i n s t a l l w h e e l o n t o n e w
crossmember.
4. Install spindle of support bracket (D)
through rear frame and secure with 3/8-16x 3-
1/2” (E), lockwasher (F), and nut
on top of frame. Spread uprights of support
bracket as required to install to rear frame,
5. Install
(I), and large flat washer (J, O.D.,
I.D.) through threaded spindle.
6. Install two washers O.D., 1” I.D.) on
support bracket spindle (more may be
necessary) and install crossmember (R)
spindle. While holdingcrossmemberfirmlyonto
spindle, rotate crossmemberfromside If
there is not at least clearance with frame,
add additional washers between
crossmember and support bracket.
7
8.
9 .
Place flat washer (L, O.D., 1” I.D.) and,
plate onto spindle and secure with washers,
O.D., I.D.) and castle nut (N).
Use washers (M) as required to fill up space on,
spindle. Tighten castle nut securely and then
back off until crossmember rotates freely.
Check that cotter pin (U) can be installed
through slot in castle nut. Loosen nut until step
is performed.
In top hole of plate (T), install
(0) and lockwasher (P) into weld
on support bracket. In bottom hole, install
similar
(0) and secure on backside of
support bracket with lockwasher (P) and
(Q). Tighten capscrews (0), castle nut (N), and
install cotter pin.
Install washer (C, O.D., 1” I.D.) onto
wheel spindles and install through bushings on
each side of crossmember. On top side, install
as required so that cotter pins
are aligned with spindle holes. Make sure
that wheels rotate freely after cotter pins are
installed.
10. Install plastic caps (A) over wheel spindles.
11. Lubricate the five grease fittings (2 on wheels, 2
on wheel spindles, 1 on support bracket).
12. Adjust tire pressure to 20 psi (137
2
FORM