Soleus Air HM1-10-01 - Manual (Page 7)

7
OPERATING INSTRUCTIONS
CONTROL PANEL
1. Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate
heater in upright position with caster wheels attached.
2. Once the heater is plugged in, the POWER INDICATION LIGHT will light up.
3. Select a heat setting:
On the control panel, turn the POWER SELECT dial to the desired setting: LOW (500W), HIGH (1000W),
or ECO mode.
4. Adjust the thermostat by turning the THERMOSTAT dial on the control panel or remote control. You will
hear a faint click noise when the thermostat is turned to a point above the current room temperature.
Continue to turn the thermostat to increase the room temperature. If the area becomes too warm turn the
THERMOSTAT dial down slightly until you reach a point where the temperature is more comfortable.
5. Once you have chosen the desired temperature, the heater will remain on until the room temperature
increases to the temperature set on the THERMOSTAT dial. The heater will cycle on and off to maintain
the desired room temperature.
6. Unplug the heater when not in use.
NOTE: ECO mode is an Economic Energy Saving Function. When ECO mode is chosen the heater will
consume one-third less power once the room temperature reaches the set temperature on the digital display.
POWER SELECT DIAL
POWER INDICATION
LIGHT
THERMOSTAT DIAL