Sony HDW-M2000 - Manual (Page 25)

Chapter 2
Location and Function of Parts
Chapter 2 Location and Function of Parts
2-15
2-2 Connector Panel
75 Ω
Cooling fan
Cooling fan
1 Analog audio input/output
section
2 Analog video input/output section (see page 2-16)
3 Digital audio input/output section (see page 2-16)
4 Digital signal input/
output section (see
page 2-17)
5 Power supply section
(see page 2-17)
6 External device connectors (see page 2-17)
8 Audio monitor signal output section (see
page 2-18)
7 Time code input/output
section (see page 2-18)
1 Analog audio input/output section
1 AUDIO INPUT CH1 to CH4 (channels 1 to 4)
connectors (XLR 3-pin, female)
Input analog audio signals to channels 1 to 4.
You can record analog audio signals input to these
connectors to any audio track on the tape.
AUDIO INPUT CUE
CUE
LOW
OFF
HIGH
ON
600
Ω
CH1 LEVEL
LOW
OFF
HIGH
ON
600
Ω
CH2 LEVEL
LOW
OFF
HIGH
ON
600
Ω
CH3 LEVEL
LOW
OFF
HIGH
ON
600
Ω
CH4 LEVEL
AUDIO OUTPUT
CH1
LOW
OFF
HIGH
ON
600
Ω
IN LEVEL
OUT CH2 CH3 CH4
1 AUDIO INPUT CH1 to CH4 connectors
2 AUDIO INPUT CH1 to CH4 LEVEL switches
3 AUDIO OUTPUT CH1 to CH4 connectors
2 AUDIO INPUT CH1 to CH4 (channels 1 to 4)
LEVEL switches
Set these for each channel as shown in the following
table, according to the audio input levels to the
AUDIO INPUT CH1 to CH4 connectors and the
impedance.
AUDIO INPUT CH1 to CH4 LEVEL switch settings
3 AUDIO OUTPUT CH1 to CH4 (channels 1 to 4)
connectors (XLR 3-pin, male)
These connectors output analog audio signals for
channels 1 to 4.
4 CUE IN/OUT (cue audio input/output)
connectors (XLR 3-pin, female/male)
The IN connector inputs and the OUT connector
outputs the cue audio signals.
Audio input level and impedance Switch setting
Level Impedance
–60 dBu
(microphone input) High impedance
(approx. 20 k
Ω)
LOW-OFF
(left position)
+4 dBu
(line audio input) High impedance
(approx. 20 k
Ω)
HIGH-OFF
(center position)
+4 dBm
(line audio input) 600 Ω HIGH-ON 600 Ω
(right position)
4 CUE IN/OUT connectors