SECO-LARM USA Enforcer SA-025 - Manual

TimerPdf070103.pmd
Other Products Available from SECO-LARM
Power Supply/Chargers
ST-2406-5A ST-2406-3A ST-2406-2A ST-1206-1.5A
Model #
ST-1206-1.5A
ST-2406-2A
ST-2406-3A
ST-2406-5A
Voltage
DC
6,12
6,12,24
6,12,24
6,12,24
Current
(continuous)
1.5A
1.5A
2.5A
4.0A
Current
(peak)
2.0A
2.0A
3.0A
5.0A
●
5-Amp relay, DPDT, Form-C.
●
6/12/24 VDC operation.
●
LED indicates power.
Relay Board
SR-2224-C5
●
Relay can be wired for load
switching, dry contact, latching,
reverse polarity, line seizure, etc.
Plus many, many other
products for commercial,
residential and vehicle
security. See our website for
details, or contact us for a
catalog .
ENFORCER
®
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is not responsible for misprints.
For more information, contact: Tel: 1-800-662-0800 (domestic U.S. & Canada)
Tel: 1-949-261-2999 (California & international) Fax: 1-949-261-7326 Email: [email protected] Website: www.seco-larm.com
SA-025 Timer Module
The SA-025 Programmable Timer Module is suitable for a wide range
of timed security and access control operations, such as door unlock
timing, siren or bell timer, and so on. Auto-sensing of input voltage
and DIP switches for programming make installation easy.
●
Timer can be set from 1 sec. to 60 minutes
●
Can be triggered by positive voltage (+DC),
or closure or opening of dry contact.
●
Relay can be programmed to activate at the
start or at the end of the timing cycle
●
Relay can also be set to activate for one
second at the end of the timing cycle
●
Programmable for pulse (flash) activation
●
Built-in reset function to manually reset
timing cycle
●
Form-C relay, contacts rated 8A @
120VAC/24VDC
●
LED indicates relay is energized
●
12VDC/24VDC operation (auto sensing)
DIP switch settings
SwitchFunction ON OFF
#1 Timing starts: At end of trigger At start of trigger
#2 How does the timing start? When the module is powered up Connecting (+) to TRG
#3 Timer setting: In seconds In minutes
#4 Steady relay output, or pulse/flash? Steady relay output Pulse/flash output
#5 When does the relay output start? At end of timing period At start of timing period
#6 Relay output mode, delayed or instant? Instant output Delayed output
●
Current draw - 3mA (standby) or 40mA
(relay energized)
●
Board measures 2 7 /
8
" x 2 1 /
2
" (73 x 63 mm)
●
Functions programmed via DIP switches -
no jumpers to cut