Sony MDX-CA680 - Manual (Page 27)

27
Error displays/Messages
*1 When an error occurs during playback of a MD or
CD, the disc number of the MD or CD does not
appear in the display.
*2 The disc number of the disc causing the error
appears in the display.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
* TOC = Table of Contents
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
t Cancel monaural reception mode (page
21).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
t Press (AF) or (TA) repeatedly until “AF-
OFF” or “TA-OFF” appears.
No traffic announcements.
• Activate “TA.”
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays “- - - - - - - -.”
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the programme
type.
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
BLANK * 1
No tracks have been recorded on an MD.* 2
t Play an MD with recorded tracks on it.
ERROR * 1
• A CD is dirty or inserted upside down.* 2
t Clean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.* 2
t Insert another CD/MD.
HI TEMP
The ambient temperature is more than 50°C.
t Wait until the temperature goes down
below 50°C.
NO DISC
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
NOTREADY
The lid of the MD unit is open or the MDs are
not inserted properly.
t Close the lid or insert the MDs properly.
RESET
The CD/MD unit cannot be operated because
of some problem.
t Press the RESET button on the unit.
Messages
L.SEEK +/–
The Local Seek mode is on during automatic
tuning (page 13).
NO AF
There is no alternative frequency for the
current station.
NOT READ
The unit is reading the TOC* information.
** WAIT **
The unit is reading the TOC* information.
“ ” or “ ”
You have reached the beginning or the end of
the disc and you cannot go any further.