Remote commander rm-980 – Sony 32LX1 User Manual
Page 11
11
(GB)
Location and Function of Parts and Controls
Remote Commander RM-980
1
POWER ON switch
Press to power on the display.
2
STANDBY button
Press to change the display to the standby mode.
3
MUTING button
Press to mute the sound. Press again to restore sound.
4
DISPLAY button
Press to display the input signal information and the
picture mode on the screen. Press again to hide them.
If this displayed information is left undisturbed for a
short time, it will disappear automatically.
5
INPUT1 button
Press to select the signal input to the INPUT1
connectors.
6
INPUT2 button
Press to select the signal input to the INPUT2
connectors. Each press toggles between RGB and
COMPONENT.
RM-980
MONITOR
MUTING DISPLAY STBY
ON
ENTER
SET
ON
0
8
7
9
5
4
6
2
1
3
2
1
3
qa
5
4
7
6
8
9
0
qs
qd
qf
qg
qk
qh
ql
qj
7
PICTURE button
Selects Picture mode. Each press toggles between
Vivid, Standard, and User 1 to 3.
8
ASPECT button
Press to change the aspect ratio (Wide Mode).
9
M/m/</,/ENTER buttons
The
M/m/</, buttons move the menu cursor
(yellow) and set values, etc. Pressing the ENTER
button sets the selected menu or setting items.
q;
Number buttons
Press to enter index numbers.
qa
BRIGHTNESS button
Adjusts the brightness when Picture Mode is set to
any of “User1” to “User3.” Press this button, then
adjust the brightness with
M/m or </, buttons 9.
qs
ID MODE (ON/SET/OFF) buttons
Press ON to show an index number on the screen.
Enter the index number of the display you want to
operate with Number buttons 0, then press SET.
Press OFF to return to the normal mode.
For details on the index numbers, see “Operating a
Specific Display With the Remote Commander” on page
40 (GB).
qd
VOLUME +/– button
Press to adjust the volume.
qf
OPTION2 button
Selects the signal input to an optional adaptor (except
BKM-V10) when you install one in the unit. Each
time you press this button, the signal input to the
OPTION2 switches.
Note
You cannot operate this button for the FWD-32LX1/
32LX1E that does not have the OPTION2 slot.
qg
OPTION1 button
When an option board is installed, selects a signal to
be input from the device connected to the option
board. Each time you press this button, the signal
input to the OPTION1 switches.
qh
MENU button
Press to show menus. Press again to hide them.
qj
button
Selects the PICTURE AND PICTURE (PAP) mode.
Each press toggles between PAP off, P&P, and PinP.