Sony HT-DDW890 - Manual (Page 22)

22 GB
If you connect a Blu-ray disc
player
• Be sure to change the factory setting of the
VIDEO 2 input button on the remote so that
you can use the button to control your Blu-
ray disc player. For details, see
“Programming the remote” (page 66).
• You can also rename the VIDEO 2 input so
that it can be displayed on the receiver’s
display. For details, see “Naming inputs”
(page 64).
Notes on HDMI connections
• This receiver may not be able to transfer
video or audio signals with certain types of
components.
• The multi/stereo area audio signals of a
Super Audio CD are not output.
• Be sure to turn on the receiver when the
video and audio of a playback component
are being output to a TV via the receiver. If
the power supply of the receiver is not
turned on, neither video nor audio is
transmitted.
• Audio signals (sampling frequency, bit
length, etc.) transmitted from a HDMI jack
may be restricted by the connected
component. Check the setup of the
connected component if the image is poor or
the sound does not come out of a component
connected via the HDMI cable.
• Video signals input to the HDMI IN jack can
only be output from the HDMI OUT jack.
The input video signals cannot be output
from the VIDEO OUT or MONITOR OUT
jacks.
• Refer to the operating instructions of each
component connected for details.
Notes on digital audio signals
connection
• When connecting optical digital cords, insert
the plugs straight in until they click into
place.
• Do not bend or tie optical digital cords.
• All the digital audio jacks are compatible
with 32 kHz, 44.1 kHz, 48 kHz, and 96 kHz
sampling frequencies.