Sunbeam DFM960 - Manual (Page 5)

3. Step on the scale and stand still. The display will blink “- - - -” and your
weight will be shown.
4. The scale will turn off automatically after a few seconds.
NOTE: It is normal for your weight to vary during the day and from
one day to another, slight changes in weight are generally normal.
Error Messages
If " EE " appears on the display, an error has occurred.
Step off the scale and carefully repeat the instructions
again.
" EE " is displayed in the upper row (fig. A) when:
1. You step on the scale before “0.0” is displayed.
2. The weight load is greater than the maximum
capacity (330lb / 150kg). NEVER apply a weight
load beyond the maximum capacity.
" EE " is displayed in the lower row (fig. B) when:
1. Your body fat percentage could not be
calculated. Ensure your bare feet are positioned
on top of the scale's silver pads.
7
Weight-only Usage
It is not necessary to have the user’s personal data programmed into
the scale to obtain an accurate weight-only reading.
1. Tap the center of the scale platform with the ball of your foot to activate
the scale.
2. Wait until “0.0” is displayed and the scale emits a beeping sound.
6
6. Once you have entered your information, wait until the display shows “ 0.0 ”,
" 0 %" and the scale emits a beeping sound. Your profile is now
programmed into the selected user button and the scale is ready for use.
Repeat Steps 1-6 to program another user’s profile.
NOTE: If no button is pushed within 8 seconds during
programming, “0 0 .. 0 0” will be displayed. Wait until the unit turns off
and return to Step 1 to continue the setup.
Monitoring your Weight and Body Fat Composition
Make sure you have programmed your personal data before using the
body fat feature.
1. Press your personal user number with your toe. Your profile will appear on
the screen.
2. Wait until "0.0" and “0%” appears on the display.
3. Stand on the scale (bare feet only!) so the balls of your feet are on the
upper silver pads, and the heels are on the lower silver pads.
NOTE: For body fat estimates, always measure with bare feet.
4. During the weight measurement, the display will blink “- - - -” and your
weight will appear. Next, the display will blink “- - - -” and your body fat
percentage will be shown.
5. The scale will turn off automatically after a few seconds.
NOTE:
Place the scale on a flat, level surface. A hard surface is
best to achieve maximum accuracy. Placing the scale on a
rug or carpet may affect the scale’s weighing accuracy.