Schumacher XI41DU User Manual
Page 5
• 4 •
CONNECTING INVERTER CABLES
3.
The inverter and power source must be in the OFF mode.
Make sure you connect your inverter to a 12-volt
power supply only.
Inverter connection:
Locate the positive and negative plastic terminals located on the
1.
back of the inverter and remove the terminal caps completely.
Install the positive (red) cable ring lug onto the positive (red)
2.
terminal screw. Install the negative (black) cable ring lug onto
the negative (black) terminal screw. Tighten each terminal so
that the cable cannot come loose.
Connecting inverter cable to a vehicle (100 watts maximum):
Remove the cigarette lighter from its outlet.
1.
Push the 12-volt power plug firmly into the outlet.
2.
Connecting inverter cables to 12v battery or 12v power
source:
Keep hands, hair, clothing and jewelry clear of battery terminals.
1.
Wear eye protection and clothing protection.
2.
Connect the positive (red) inverter terminal cable to the
3.
power source positive (+) or battery terminal. Make sure the
connection is secure.
Connect the negative (black) inverter terminal cable to the
4.
power source negative (-) or battery terminal. Make sure the
connection is secure.
To disconnect the inverter, reverse the above steps.
5.
NOTE: The internal speaker may make a brief “beep” when the
inverter is being connected to or disconnected from the 12-volt
power source.
Failure to make the correct connections will result in
blown fuses and permanent damage to the inverter.
OPERATING INSTRUCTIONS
4.
Connect the inverter (see “CONNECTING INVERTER
1.
CABLES” section).
Make sure the device to be operated is turned OFF.
2.