Smithco 72-000-A - Manual (Page 11)

9
Service
OPERATION
Before operating this machine, become familiar with all controls and functions of this unit and the tow vehicle.
Also complete all maintenance requirements and read all safety warnings. By knowing both machines thor-
oughly, how it operates and by doing the prescribed maintenance steps, you can expect relatively trouble-free
operation for years to come.
TOW VEHICLE
You will need a 40 HP minimum tow vehicle.
1. Clevis Hitch - You will need a 3 /
4
diameter by 4" pin with some type of lock.
2. Ball Hitch - You will need a 2 5 /
16
" ball and a locking pin for the coupler.
DAILY CHECKLIST
1. Check engine oil level in tow vehicle. Add as needed. DO NOT OVERFILL.
2. Tire pressure should be 18 psi (1.3 bar) on Big Vac tires and 20 psi (1.4 bar) on castor wheels.
3. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
4. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
5. Check hydraulic fluid level in tank. Look at the sight gauge on the front left side of the tank. The oil level
should be at 90°C (194°F). If level is low, add SAE 10W-40 API Service SJ or higher motor oil.
6. Check controls for smooth, proper working operation. Lubricate as needed.
7. Check and clean all debris from blower housing.
ADJUSTMENT OF BELT TENSIONER
There are four maximum belt tensioners on the Big Vac. Two control the tension
on the belts on the blower housing, one each on the finger reel and the thatcher
reel. The proper tension of the idler should be 12 to 15 as per the gauge (A) on
the side of the tightener. Over tightening the belt will shorten the life of the belt
and the machine may not perform to the best of its ability. To adjust belt
tensioner, loosen bolt holding tensioner. Bring idler pulley tight to belts and turn
tensioner into belts to 15°. Tighten holder bolt.
CONTROL PANEL ADJUSTMENT ARM
On the right hand side of machine is the
adjustment lock arm, by lifting up you can
adjust the control panel by moving it forward
or rearward. Make certain that the lock arm
is locked back in place after adjustment.
For up and down adjustment loosen the four
adjustment bolts place the control panel to
where you want it and tighten the four bolts.
HITCH OPTIONS
You may use the clevis hitch that is shipped
with your machine or a 2
5 /
16
ball hitch that is
an optional accessory. Both mount in the
same location with three different bolt hole
options.