Swann 4-Alert SW242-DAL - Manual (Page 9)

User Manual
PRESS (UP DOWN), ENTER (SELECT)
PRESS (MENU) TO EXIT
MAIN MENU
CAMERA SELECT 1 2 3 4
RECORD SELECT 1 2 3 4
RESOLUTION EACH
RECORD FRAME 25
RECORD QUALITY HIGH
SCHEDULE SET
MISCELLANEOUS MENU
HARD DISK SET
VIDEO MODE PAL
MOTION SET
FACTORY RESET
[ SEL]: Select/modify settings
[
Menu]: Press exit/previous menu
[
Menu]: Push to enter system menu
[ Up] and [ Down]: Move the cursor
5.2 Camera Select
- 6 -
The DVR system can display 4
cameras at once or you can limit the
number of cameras displayed to save
HDD space.
Press [
SEL] to modify setting, or
press [CH1], [CH2], [CH3] and [CH4] to
set each channel separately.
If a channel is disabled, the system will display “OFF” on the monitor; this
channel will not be recorded. (Refer to 5.3 Record Select)
5.3 Record Select
Manually set which channels are allowed to record.
Note: If no channels are selected, an error message will appear briefly on the
screen when record is selected. “1234” indicates all cameras are set to record.